Noorio sensors can only be installed indoors.
Installation Methods
Noorio motion sensors can be mounted with 3M stickers or screws.
|
Sticker |
Screw Mounting |
Preparation
Before you mount, you may need a screwdriver, a drill with a 15/65 inch (5.95 mm) drill bit, and a ladder.
Installations Tips
1
Please tear off the protective film. Otherwise, it may affect the sensor's performance.
2
It is recommended to install the motion sensor on a wall facing or next to an entrance.
Installation Method 1: Sticker
1
Tear off one side of the film on the 3M sticker and stick it to the bracket.
2
Tear off another film of the 3M sticker and stick the bracket to flat surfaces.
3
Attach the motion sensor to the bracket and adjust it to an appropriate position.
Installation Method 2: Screw Mounting
1
Install on wooden, plastic, and other soft materials: Srew the base of the bracket onto the wall directly.
Install on concrete, brick, and other hard materials: Drill a hole with a 15/65-inch (5.95mm) drill bit. Insert the anchor into the hole and finally screw the base of the bracket onto the wall.
Install on concrete, brick, and other hard materials: Drill a hole with a 15/65-inch (5.95mm) drill bit. Insert the anchor into the hole and finally screw the base of the bracket onto the wall.
2
Attach the motion sensor to the bracket and adjust it to an appropriate position.
